|
- Water heater drip pan or other suitable device that will allow the water to rise to a level of 7/8”. See sizing chart below.
- Two ¾” male threaded x sweat adapters
- Two lengths of copper(or other approved tubing). Length will vary by installation. Connection from cold water supply line to valve and from valve to the “cold in” port of the water heater.
- Two to four (depending on the installation) 90° copper (or other approved) elbows.
Drip Pan Sizing:
Water Heater Diameter
Up to 17.75 = min. 20” pan
18” – 23” = minimum 24” pan
24.5” = minimum 26” pan
|
